So I'm putting an ARB in my 8.25. I previously geared to 4:56 7 years ago.
Anyways I checked backlash and turning torque before disassembly. Back lash was .009-.010".
I have the arb installed and back lash set right at .009-.010".
I have new carrier bearing installed so my question is should I go a bit tighter on back lash or setup exactly as I took it apart? I'm just wondering if back lash will open up a bit...
Anyways I checked backlash and turning torque before disassembly. Back lash was .009-.010".
I have the arb installed and back lash set right at .009-.010".
I have new carrier bearing installed so my question is should I go a bit tighter on back lash or setup exactly as I took it apart? I'm just wondering if back lash will open up a bit...