BoringDave
NAXJA Forum User
- Location
- Boring
I have been battling a no start issue here we go.
last owner installed in an attempt to get it to start.
new crank sensor
new cam sensor
rebuilt starter
I have power going into the pcm at pins b7 and b8 key on
I have good ground at pins b11 b12
I have source voltage to the tps from the transmission computer to the square connector
All the sensors have good ground
I do not have source voltage out of pins c14 to the map or c15 to the tps
I have not figured out how to test if I have tach input to the computer yet?
But I am more worried about the lack of source voltage to the tps and map being my problem.
Am I on the right track to buy a pcm?
I took this one apart and it looks and smells fine. I have a want to buy or barrow post up in my local chapter now for a known good test unit.
So I guess i'll see what happens! Any help will much apreshiated (sp?)
Dave
last owner installed in an attempt to get it to start.
new crank sensor
new cam sensor
rebuilt starter
I have power going into the pcm at pins b7 and b8 key on
I have good ground at pins b11 b12
I have source voltage to the tps from the transmission computer to the square connector
All the sensors have good ground
I do not have source voltage out of pins c14 to the map or c15 to the tps
I have not figured out how to test if I have tach input to the computer yet?
But I am more worried about the lack of source voltage to the tps and map being my problem.
Am I on the right track to buy a pcm?
I took this one apart and it looks and smells fine. I have a want to buy or barrow post up in my local chapter now for a known good test unit.
So I guess i'll see what happens! Any help will much apreshiated (sp?)
Dave