mikeny59
NAXJA Member #300
- Location
- NY and/or Fl.
Ready to pull axle shafts, FSM requires special tool(s) that describes installing bearing until face of Miller tool contacts axle tube face, which means that bearing travels deep enough to leave room for 3/8" or so for seal.
Tool w/handle is like $50.00 and three weeks away, I'm thinking cutting a round piece of wood slightly narrower than axle tube, bottoming out bearing (assuming there is a shoulder to stop bearing at correct depth), and popping in the seal.
Sound logical?!?
Thanks,
Mike
Tool w/handle is like $50.00 and three weeks away, I'm thinking cutting a round piece of wood slightly narrower than axle tube, bottoming out bearing (assuming there is a shoulder to stop bearing at correct depth), and popping in the seal.
Sound logical?!?
Thanks,
Mike