So I got my throttle body bored out to 60mm at a local machine shop, and I re-assembled the throttle body today. When I was reassembling the throttle body, I noticed that the long round shaft that you screw the throttle body into was not going in properly. I had to turn it firmly and it clicked into place...Now when I installed everything back in my car, I have a CHECK ENGINE light on. I scanned it and I got a P0123 error. Has anyone ever had this problem? P0123 - Throttle/Petal Position Sensor/Switch A Circuit High Input. The bid question is how do I solve this and SOLVE IT FAST. Any help/suggestions are welcome. THANKS
JOe
JOe