Search results

I bought my wife's soon to be daughter's 2001 xj a year ago with minor damage on the front passenger side. I pulled the front end off and bought a new header panel, grille, bumper with ends and had everything repainted. When I pulled all the old stuff off it was hanging from under the right...

So, I did some searching about the airbags and could not come up with anything pertaining to my particular situation. I bought an xj a year or so ago that had some minor passenger side front end damage. I have to replace the bumper, grille, header panel and passenger fender/bumper cap. When I...

Have some spares left over from when I parted out my xj. The front axle shafts are from a 1982 Wagoneer. Dana 44 driver drop. 82-89 should all be the same with the exception of the 86-87? vacuum disco. short side shaft $50 long side shafts $75 each The 2 shorter front drive shafts...

I had it machined and rebuilt 3 yrs ago. It was in a trail only xj. Has less than 5k on the rebuild. 3 angle valve job melling high volume oil pump rv cam The harness and ecm went the the chassis. The wiring was a birds nest anyway. An ecm and harness can be found and had for cheap at just...

I used it for a bout a year. It has everything except the toggles and a few wire connectors. http://awshifting.com/controller.htm It will also come with the joy stick style controller. http://happcontrols.com/driving/50811000.htm $150 shipped to your door. 817-891-1173

Sunray built 9" housing big bearing pockets shaved bashing strap drain plug full drum brakes 63 wms You will need third 35 spine locker/spool 35 spine shafts bearings/ brackets to keep the shafts installed $350 817-891-1173

This thing is brand new. Not much else to say about it. All the info is in the link. http://www.pscmotorsports.com/sg621mr-tj-xj-yj-cylinder-assist-steering-gear-p-89.html 817-891-1173

Brand new with the shipping label still on it. I do not need it. $95+ shipping. Trying to recoup some of my money. http://www.tntcustoms.com/page.asp?pageid=61

dana 44 out of a 1982 wagonner Complete set up for the tj/xj drivers drop lp chrome molly shafts 300 m u-joints knuckles drilled out for over the knuckle one ton steering re tj bracket kit jeepers creepers diff cover 5.13 gears lock rite disc breaks warn locking hubs spare knuckles (can...

AW4 auto new torque converter rebuilt last nov. has less than 500 miles on it. $650 obo + shipping 817-891-1173

T-case out of a Rubicon. I already have the yokes on it to match up to any 1310 drive shafts front and rear. This was mounted in my xj but is now on my garage floor. Here is a little info on it. http://www.novak-adapt.com/knowledge/np241or.htm 4:1 32 spline output shafts 23 spline input...

The prices are non negotiable except on the axle, transmission and long arm because of the amount it may cost to ship those three items. Rusty's 4.5 coils $75 http://rustysoffroad.com/mm5/merchan...ory_Code=COILS T n T Customs Long Arm Kit $750 http://www.tntcustoms.com/page.asp?pageid=169...

How much axle droop should a leaf pack allow? I have BOR leafs with a boomerang shackle. I unbolted the u-bolts on one side and lifted it. The leaf became separated from the axle as I lifted and then the tire came off the ground. My shock allows for 3" of droop. Will the spring droop further...

I bought my case the Monday after I got back from Superlift ORV Park and before I was supposed to go to Clayton, from a yard in CA. I had trashed my tranny (AW4) while at Superlift. So Sunday night and Monday morning I searched and searched to no avail for pics and some sort of a write up that...

passenger side rear quarter glass--------------------$15 driver side rear quarter glass-------------------------$15 passenger side rear quarter glass w/ vents------------$30 driver side rear quarter glass w/ vents----------------$30 hatch glass-----------------------------------------$20...

I went to the metal supplier to get some 1.5" 120 wall electric weld tube that I have used many times. The guy in the warehouse gave me these sticks of tube. I know it is not the electric weld tube so I need help identifying it.

How does the wiring harness come off the back of the fuse box? I want to reroute the harness but, I can't figure out how to remove it. What's the trick?

I haven't been on here in a while. Here is what my rig looked like last time I posted. Then I went from 36"s to 38"s. I tried on some 39.5 Iroks but I decided they were to ballony and I was getting past the limits of my front axle. I went out this past weekend and decided that the bidy...

I have a 9 with drums mounted under the rear of my xj and I have not had an e-brake since its install. The e-brake lines that were on the 35 were shot and tossed. What e-brake lines that will work with my 9?

How do you quote 2 or 3 or 4 different posts in one thread in a single post? For instance to answer 2 or 3 questions from different people without having to do a seperate post for each question. I can not figure it out.