Search results

Finally found the post where I found the solution: https://www.reddit.com/r/AskElectronics/comments/22msmd/wiring_a_wiperwasher_switch_in_my_jeep/

Here's the write-up I did on my install. Came our really tight but was a ton of work. https://www.reddit.com/r/CherokeeXJ/comments/1z3np8/topic_xj_dash_project_custom_switch_mount/

Got everything working after testing the connections. For those interested, updates to the wiring diagram for the rewire are below. I wired this to be able to engage front and rear independent of one another. I'm using SPST Carling switches not the stock ARB ones so they are setup a little...

Plan to cut out the floor and build a battery compartment for a sealed plastic battery box to fit in.

I'm adding a second battery to my rig and am trying to keep as much space as possible available under the hood for a York. Has anyone relocated their battery under the rear seat? If so, any lessons learned?

Thanks for the help. The CPS was shot but the rig fired right up after I replaced it. BleepinJeep has a pretty good tutorial on the process of replacing it for anyone in need.

Thanks for the help - CPS is showing infinite resistance between B & C. New MOPAR sensor ordered.

My 1999 XJ won't start. The motor turns over but never fires and there are no issues with the starter, ignition, lighting, etc. After several hours of going through all the fuses and relays, it looks like they are all fine. I have found that I'm not getting power to fuse 21 and 24 in the PDM...

Good catch on the ground wire. I do not have anything other than the yellow and dark green connected to the harness since the pod provides common ground, 12v+ and illum. I will ground those and see if that has any effect. I'm getting about 10.5v+ at the 3 pin which may be due to using the...

I'm not running the ARB switch, I'm using a Carling V1D1GHCB which has a common ground (pin 7) and uses pin 8 for illumination: http://www.otrattw.com/wiring/G66.pdf The ARB switch is a V1DA which uses pins 7 and 8 for independent grounds...

I've hit a stumbling point and I'm looking for some help. I've build a DIY SPod for my Jeep XJ (1999 Cherokee Sport). I'm trying to wire the lockers to a couple of Carling Contura V switch bodies. I have the compressor wired to the ARB supplied loom and am planning to move the switches to the...