Search results

Sold.

$3500 firm.

The sooner the better...what did you have in mind?

Yes he does. It would just use different end caps.

Yes, it is.

Somebody buy this thing. My loss is your gain.

1997 XJ 156k miles, 4.0, AW4, NP231w/ Crown SYE, D30 w/ 3:55's open, 760x joints, C8.25 w/ 3:55's open, RC LCA's, 3" RC front springs w/ 1.5" spacers, 3" Superlift rear springs w/ AAL's, 1.5" lift RC shackles,32" Kumho Venture M/T's on 15x7" Cragar Black D Windows, JKS Steering Brace System, IRO...

Sold.

Hi Pinion Dana 30, non vacuum disconnect, factory 4.10's. Reinforced LCA mounts. Comes with stock steering setup and steering stabilizer. Just needs brakes and it will bolt in to an XJ, MJ, ZJ, or TJ. $325

Any other input before I pull the while dash apart? Could a blend door problem cause significantly restricted flow?

What did the problem turn out to be? I am having the same symptoms.

But would a blend door failure cause restricted flow?

The air flow in my '97 XJ's HVAC system seems to be restricted. Barely any air comes out of the vents no matter what the fan speed(when I increase the fan speed the flow from the vents dosn't increase). Heat or cold it flows the same. It does divert the air to the proper vents. I pulled the...

Re: Need opinion on axle shafts Then why not just use stock shafts with 760-X joints?

I have 2 rear TJ Flares. Send me a PM if you are interested.

Here is a built '95 XJ. He is asking $5995. http://www.jonfund.org/forum/ubbthreads.php?ubb=showflat&Number=114059#Post114059

It's not shown on their site, but they do make it. Call or e-mail them. It is called the RbM(rear bumper modified).

I'm planning on getting a Rigid bumper. They make one just for that mod.

My nutserts pulled out of the frame. I cut a hole in the floor pan, and welded a piece of steel plate with 2 nuts welded to it inside the frame rail as a permenant solution. I also upgraded to 1/2" hardware.