Search results

in MJ's or XJ's

Peep this, cherokees are still for sale in Scotland! I took this pic in Fort Williams, but they're all over. They're right hand drive but you could get used to it. http://memimage.cardomain.com/member_images/3/web/423000-423999/423496_11_full.jpg

Will pre-97 doors, fit a 97? (front doors on a 4 door, for half door purposes)

Anyone done something like this? I want to tie my bumper into my sliders, hog out my wheel openings, for protection as well as plate the tube then bolt/weld? to my body to act as a fender. I've seen them on CJ's and Cruizer's but would the unibody cause me some problems? flexing and such.

Ordered my 32x11.5's on 15x8 black uglies with 3.75 bs, I have a sagged 2" budget boost on my 97 (bought that way) going to trim fenders tonight (a lot) I have some ZJ coils, MJ shackles, TJ fender flares (to come soon) all that I plan to later add as needed. Any advice anyone have before I...

thought I'd toss a pic of my new bumper on here, took some inspiration from madxj. simple and effective, took about a day to plan, build and finish. http://images.cardomain.com/member_images/3/web/423000-423999/423496_8_full.jpg...

Pulled my front bumper off last night in preparation for fabbing my new one, and stuck on the inside is a softball sized plastic ball bolted to the bumper with a vacuum line attached to it, when I pulled off the line it released some pressure. I followed the line and it ended at my intake...

32x11.5's on a stock 15x7 rim, will I rub a lot? I will be running TJ flares as well, should I get some wheel spacers? I want the flares and tires to be somewhat flush. thanks.

Bought some out a 5.2L 93, unloaded only about 16" tall are these the rears? are they sagged or is this it? cuz I thought they were supposed to give me lift and they look short.

for a 97, I have the MJ shackles but should I use a Dakota main leaf or an MJ main leaf for my add-a-leaf, I want to net 2" with MJ shackle. Which one is easier? better ? thanks.

Full set of flares in like new condition for a 1997 4 dr $70, shoot me an e-mail [email protected]

I want some. gimmee an e-mail [email protected] if you have any or have a line on a set of TJ flares.

Opinions? I'm looking to put a 31x10.5 or even 32x9.5 on a 97 with around 2"s of lift, I know I'll need to trim but do you think it would be better to run a ZJ coil and a 1" spacer than just a 2" spacer being that the ZJ coil will be stiffer and harder to stuff in the wells, but still provide...

does anyone know if the MJ coils are taller than XJ's? I pulled some MJ coils out of the junkyard because they measured out at 19 & 1/4" I'm not sure if these are stock or aftermarket or ZJ coils, can someone solve this mystery for me, I want to know because I'm looking to add these coils to my...

I found some coils out of a commanche today that measured 19 and 1/4 inches, which seemed 2 inches and some taller than XJ's, are these stock MJ coils, ZJ's or aftermarket? and will they fit and give me 2" lift in the XJ front? sorry for all the stupid newbie questions. is there a site that...

should I pay for junkyard ZJ coils? I got a line on a set for $50 the rest were 75 and up. I'm assuming these are the reg 5.2 liter coils. I'm hoping to get an inch of lift out of them. then I found some MJ shackles for $10 for the pair.

I've been lurking for a while trying to figure out what to do with the 97 I just bought, don't have extreme dough and don't want to mess with death wobble. here's what I came up with. 2"s and 32's sounds good, I'm thinking 1" spacer (already have spacer), 5.2 ZJ coils (not up country) in front...

Just bought my 97 XJ today, it's got 1" spacers on it now but I want a couple more inches to clear 31's, are stock ZJ coils a good/cheap way to do this? then add some shackles on the rear? it's already got a 1 inch block. And what other stuff do I need to consider as far as steering or...