Recent content by xj95

Hy I have a xj 2000 and i would like to know what's the heigt of the truck. Where do i measure to know if the sprig and leaf have lost its regidity. Thank you sorry for my poor english zzzzzzz

HY This past fall I install a 3" lift since then I have been experiencing with vibration. I still have the original ujoint 180k but they dont show any loose.My spring pack came with a shime to correct the angle.the dshaft is in line with the pignion yoke of the differential. I know that some...

Hi Took a look of the ujoint of the rear dshaft everything is ok but I notice some loose on the the shaft coming out of the tcase about 1/16 to 3/32 of movement when I push on it up and down is it normal for a 180k xj. thank Zzzz

Hi Took a look of the ujoint of the rear dshaft everything is ok but I notice some loose on the the shaft coming out of the tcase about 1/16 to 3/32 of movement when I push on it up and down is it normal for a 180k xj. thank Zzzz

do you have any back spacing and how much trim did you cut I also have a 95 Thanks ZZzz

Funny just sent a post on this issue.Installing the ½ inch bracket I like to see how you fit it on the frame.The sway bar must be very close if not rubbing on it. If you have any picture of it I appreciate it Thanks Zzzz

Hi I was looking at your bracket for the bumper and I was questionning if ¼ inch was thick enough, with your experience do still feel it was the right choice. For my bumper bracket I was going for ½ inch but its pretty thick and leave very little space for the sway bar to move up especialy if I...

oups forgot I have the select trac transfer case is it compatible Zzzz

Hi I found two d44 a front and a rear coming from a 74 Bronco, is it very hard to fit on a 95 XJ. What are the modication involved are they much larger than my chrysler axle. Any info will be appreciated. Thanks Zzzz

Hi I didn't understand how madxj connect the wire from the batterie to engine, alternator, accessoiries. any info is welcome Thanks Zzzz

I like your wheel who make's it Thanks Zzzz

Hi I have a 95 xj with 8.25 no lok there is a guy who wants to sell me a tracklock from 99 8.25. Do you know if it's a bolt on installation and do you have any thing in mind I should be looking for before I buy this part Dont whant to invest to much in my old 8.25 Thanks Zzzz frenchi

Hy what do you mean by BB Thanks Zzzz

hello What DD mean ? Thanks

hi very nice job,two question came in to my mine could you have install the braket on top of the axle and when you weld so close from the gaz tank do you take any safety mesure, me I'm to skare of explosion.A week ago some guy blew himself in is garage doing some work on a freind's car.When...