Recent content by willy3

Does anyone know how to adjust a 1 bbl Rochester carb on a 65 Chevy truck?

Yes; but should I use the 91 or 99 gasket?

I have a 91 XJ 4.0 with a 99 intakemanifold. When I first installed the intake I just used the same gasket with silicone sealer as I did not take the exhaust manifold off. I am now going to put a header on and will get a new gasket. I noticed that there are different gasket part #s listed at...

I searched "steering box" and did not find it so here goes. My unibody "frame" is/looks bent (creased) where the steering box mounts to it. I can see a ridge bend/crease between the steering box mounts. I have a steering box support rod from Rusty's and also long winch bumper mounts and a...

Thanks for all the the input. I am still learning how to search for previously covered topics. I will try not to duplicate questions anymore. I have already installed a bored out throttle body and larger Hesco spacer, added a home made air tube with K & N cone, a complete 2 1/2 inch exhaust with...

Hello, I am new here. I have a 91 XJ with 4.0 HO that I am working on now. I have read about replacing the intake manifold with a 99 up as it was redesigned. I understand I use my fuel rail and injectors and a power steering pump from the 99 up as well. Has anyone done this that could comment...

Mine did that with a 91 4.0/AW4 after replacing the engine & trans mounts. I took it to the redneck muffler/tire shop nearby and all they did was use a transmission jack under the exhaust pipe to bend the rod that goes into the rubber mount up at the point where the exhaust goes through the...