Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
somewhere i had a writeup i found online about roller painting.
ah ha, i found the link. hopefully it works and the pics are still there
http://board.moparts.org/ubbthreads/showflat.php?Number=2348049
I don't think that electric ones are worth anything. I bought the cheapest gas one from sears about 5 years ago and it absolutly blows away every electric one that I have used
Unless you want to use it somewhere you cant run an engine. Its gas all the way.
please educate my simple mind. how is injecting exhaust going to lower comb temp??? i see one of two things happening:
1: the hot exhaust is going to raise the intake temp, there-by also raising the comb temp.
-or-
2: the exhaust will cause it to run a little rich( injecting air with litttle to...
this might be somewhat of a goofy question and a little off topic, but are they 13mm or 1/2" 12 point??? i used a 1/2" and it fit good and snug. maybe 13mm and 1/2 are close enough. (13mm = .511")
i just noticed that this is my 100 most..... yaay to me
all i can say is:..........wow...
it looks like a toy car gone horribly wrong. just need some gold spoked rims with a crazy offset so it looks like a cracked out go-kart
thats a minivan i would definitely drive. 6 wheel drive. gotta love it, to bad they were just playing in that small stuff, i want to see it get tested.
1/2 inch impact
3/8 ratchet
angle die grinder
i use all 3 of them all the time, in fact when i did my front u joints i used each of them. next on my list is a straight grinder and prolly a nailer of some type.
i recommend getting a pretty good impact, but you can go with harbor freight for the...
that's exactly what happened to mine. Turned out one ujoint was pretty frozen. Ant the other one was bad too. Both were dry and rusted. Axle joints btw.
is it necessary to keep this?? i pulled the bearing housing to change the u-joint and the shield fell apart. i'm not as much worried about damage or anything to the rotor as i am about clearance in the diff.