Recent content by Rob Crouch

My buddy and I are struggling to figure out this electrical problem on a 96 xj. The jeep just died a few weeks ago and wouldn't start. It cranks normally and everything seems to be fine but it wont start. We figured it was probably either no spark or fuel issues. We started by removing the fuel...

That makes since. I will have to work on that for sure. After closer inspection it seems like the clicking is coming from the driver side door. There is no similar sound in the driver side door. Does that change anything?

Yeah Its just a clicking noise. and It happens when I flip both switches. The lights are on. So I think the switch side is good. The wires are sending power as well. That leaves the circut breaker. Where is that located? and how do I test that for failure? Sorry for such a long response time- I...

I have a 99 xj sport with power locks, as well as power windows and mirrors. The power locks have been acting up recently. Probably about 70% of the time I flip the lock switch, the doors do not lock. The only thing that happens is a clicking noise I hear from under the dash. Then I can come...

I just replaced my front axle. Got It all in and, thankfully everything seems to be working well except... I have a steering shutter. When I make a turn It shutters just like when your in 4 wheel. I know I am not in 4 wheel drive, so I am a bit confused. Everything is tourqed, I aligned it...

One last question, why would it be best to get an axle from a 96-99, Would I have to modify anything to make a 91 -95 work?

Right on, thanks guys

really? I can put any year under it that doesn't have the vacuum discos on it as long as it has the right gear ratio?

My 99 XJ was recently in an accident and I need to swap out my Dana 30 front end. I am looking for a new one but am confused on the exact dana 30 type I need. I do not have ABS and my gear ratio is a 3.55. I know I don't need the vacume actuated 4 wheel drive but wouldn't know how to spot it on...

The bottom of the passenger side tire leans outward about 1" more than the top of the tire, while the driver's side tire is relatively vertical. We looked at the C's on both sides and it appears the top portion of the passenger side C was bent in and up slightly. Suprisingly, this condition...

I recently got hit on my front passenger side. After fixing a few things on the axle it is now drivable, but my caster is still off....way off. The ball joints still seem good. After an inspection I think the cast steel piece that the ball joints are in is bent. Does anyone know of any way I can...

Would You happen to have a good muffler and tail pipe? ROB

Is there only one brake line? if there are 2 Ill take em.

http://www.projectxj.com/mods/rocker.replacement.htm I am thinking about doing the same thing. This guys plans look really sweet and also bullet proof. Check it out. Its the way I am going to do it. Well if I can convince the teacher! Good luck!

I'll have to check out crawltec. Thanks for the advice!