Recent content by red_01_xj

Take a flapper wheel to the edge an you can find where it is spot welded, drill them out and take a chisel to it. After all said and done you can just bolt it back down or weld it down (Mine looked like yours so I just bolted it).

New they are that price!

If any one is interested, I have my bike for sale on Craigslist, willing to do partial trades on just about anything, especially if it will work for my XJ. http://minneapolis.craigslist.org/hnp/mcy/1982950146.html

Key Features: 4.5" Rubicon Express Short Arm/Super Flex lift with Mono Tube shocks Dana 44 Rear axle with Alloy Shafts,ZJ disc brakes, 4.56 gears, Detroit Tru-Trac, and homefab diff guard Dana 30 HP disconnect with factory 4.56, solid shaft conversion, ORO Uturn Steering, PowerTrax Locker...

yes

Anything will do at this point... While I do enjoy the finner beers anything that is on sale is what I buy, just finished up a 24pack of Michelob Ultra that was on sale for $10.59

I am a fan of IPA's, and the hopper the better. I typically like to drink local beers of the area...currently my two favorite are

Yep...I'm graduating in a few days and looking like crazy...It would take a load off of the mind!

I have to agree, yet finding entry level jobs are hard to come by, everyone wants 3-5 years....If anyone know's any job openings. I am a Graduating in 2 weeks with a B.S. Civil Engineering. I have passed the FE, and have 4 years Construction Inspection/Materials testing work on my resume. PM me...

To be honest anything that RCP Phx posts about any one else's fab work besides his own he critizes to no end, just ignore him unless other people agree, heck even on that note dont listen to him...if you don't beleve me reseach his posts On a side note IRO has got to have one of the best...

ah, I would measure mine for you, but same story

I am assuming the measurements are the same on XJ as the light bar.Check it out, on your jeep

The main reason that I suggested that the cross bars be round is that round is stronger/lighter than a square tube. Look at how the load impact of being leaned into a tree or rock, it would act like a column in a building. I agree with the H.D. Offroad Engineering for leaving the square to...

Its just what I have been looking for, however like others have posted/expressed the side rails just don't seem right, and wondering if there would be an option to have the top cross bars round?

there was a fiberglass one on there a few years ago