Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
HI all,
Anyone have a transfer case in good shape they don't need or have been trying to sell.
The forks shifted around in mine and were grinding into the side of the case. Mine is trashed, last piece to finally get me back on the road.
peepers
the fuse says flasher / stop. is there a different one? my brake lights stop working if i pull it out. i guess i was hoping there was some relay box under the hood for the hazards exclusively.
the switch is physically cracked and the flashers are engaged in the steering column. i can't turn them off until I take apart the column or do it electronically.
1990 jeep xj
hola,
my hazard switch is broken in the steering column. I cannot turn off the hazards without killing the brake lights as well by pulling the fuse.
is there a relay or switch in the engine compartment that controls hazards I can unplug?
I cant fix the column now and to be...
PROBLEM SOLVED
Finally resolved the issue. Bad Fuel Pump. At ignition I have 30lbs PSI at Idle anywhere from 31-36 just like the manual says. Starts immediately now, no backfiring, no hesitation under pressure, and I actually have fuel at the fuel rail squirt out if I press on it. Prior to...
i finally rented a fuel pressure gauge.
At the on postion the guage sees no increase in pressure. I start the car and the pressure slowly builds to ten psi, then i have to restart and it finally works its way up to 15 psi starts and idles around 20 psi. When driving it never goes above 23 psi...
been a long time since i looked at the thread.
i haven't changed my problem. I thought it was bad EGR valve and still do with the failed NOX emissions test. I don't know how to test it, and couldn't find a vacuum problem. I suppose that little hose may be worth looking at.
same symptoms...
i haven't had the time to replace the pump. I want to test the fuel rail before so. Anyone know the standard fuel pressure off the rail?
Longer Crank times, hesitation, backfiring and loss of power between 20-45 mph when gassing it, and gassy exhaust smell.
it does idle fine at 500 rpms, and...
I double checked fuel filter and even replaced that little hose on the engine end of the filter.
the fuel pump hisses. I've been reading on here its pretty common and didn't necessarily mean it was bad.
What psi should fuel pump be sending fuel to the rail? would a bad fuel pressure...
is it possible to have an air bubble in the fuel line if you dont clamp it off?
Is clamping off the fuel a "must do"?
Much like burping a coolant system in the RENIX, is that necessary to prevent future fuel problems?
Hi All,
I've been sitting on my hands the past couple weeks a bit stumped.
90 Renix 4.0L
I have replaced plugs/cap/rotor
Jeep cranks longer to start, always starts. Now, it hesitates and loses power between 20-35 mph, when you give it gas.
I'm stuck, I don't have a fuel pressure gauge...