Recent content by Motornoggin

Pm sent

Is this still available? Any pics? Sent from my SM-T700 using Tapatalk

That's what I was thinking. When we get parts in, every single part number and its quantity gets matched with what's on the packing slip, and scanned in the computer. We also match the purchase order with the packing slip. If these guys aren't doing that, then they are just asking for problems.

I run a locked, non c clip 35 under my 89. I have replaced it once due to a failed carrier bearing. It destroyed the gears. Otherwise, I have had zero issues.

That's exactly what I thought. It should have had oil up there before he started it. When I rebuilt my 4.0, I primed it, fired it up and promptly had to shut it off, as I had no oil pressure. I chased it for a bit, and finally connected a gauge right to the port. Suddenly, I had pressure! Turns...

Agreed Torx! The thing that really pisses me off is that this impacts every one of the users of TSF. Barret has done more for us than many people realize, including creating these machines and for someone to just jack it is like a slap in the face.

Hi Everyone, On the heels of the good news about the arrest of a suspect in last summer’s rash of vehicle break-ins comes terrible news from Barrett Brown about a theft from the Northwest Trail Alliance of their new ST240 single track trail machine, it’s trailer, and several other trail...

95 4.0/AW4 The left half of the cluster lights up (tach, temp and fuel) the other half and climate controls are dark. Any ideas?

This makes me smile! LOL

Dustin pretty much nailed it. Hogsback is not that hard, but it is tight and twisty and I would be surprised if a full width rig fit. Same with the upper section of FB5. There are a couple of spots where I have had to back up to make the turn, and my XJ just a bit over stock width, and stock...

No kidding! My drivers front door has been stuck closed for a week! I have been messing with it for the last hour and finally came in to search NAXJA! Lo and behold, Kastien's trick worked!!!!!! Thanks!

I have been running a Flowmaster HushpowerII for a few years and couldn't be happier with it. It's two layers of stainless with a kevlar wrap in between. Nice and compact, and stays cool. I had a 40 on it before and it did almost set my carpet on fire. Granted, my EGTs were probably high. I was...

With the way it's being driven, it's gonna need some work when it gets back! :D

Looking at this picture, I would be concerned about the piston fitting between the mains on the block. It isn't that hard to pull the head off. You have to disconnect some stuff, remove the valve cover, loosen the rockers, pull the pushrods out and yard the head off. You don't need to remove...

Apparently I did. I remember almost every post but the two that seem to say what I said. :banghead: