Recent content by moparjim1987

Dont forget that 04-07 dodge 2500 uca's work great for lca's on rigs running around 3-5" lift, most places you can get them cheap. just use washers to shim them towards the inside for tire clearance as the bushing sleeves are about 1/4" narrower than stock xj's. plus, they're boxed and have...

Beautiful fab work, everything is well planned ant thought out. nice to see people who can do this quality of work out there....

thanks guys, was kinda thinking that way anyways, even if i was to find another harness, it probably would break soon thereafter anyways.

Does anyone with a 97 & up xj have this problem? when i first got the truck, the 3rd brake light and the power lock for the hatch didnt work. Then the wiper, and finally the liscense plate light gave up the ghost. Well, was re-locating the liscense plate on sunday when putting on my tire...

just did this mod on my 97 last night, works great. cant wait to try out the winch with the higher idle now....or lights.....or anything else for that matter.

sorry i havent gotten back to replying. just to help my idea along, there is alot less things to go wrong with the 3 spd trans, they are very strong, and are cheap as hell to rebuild. i have the 727 torqueflight in my 87 dodge truck. the truck that the transmission came out of had well over...

I've been thinking of swapping my aw4 in my 97 xj for a 3 speed out of a wrangler. point being is i can run a lower axle gear and actually build the trans so it lasts longer and shifts firmer. i could possibly use a manual trans pcm, and use a shifter out of a zj, cause they use the same basic...

pull the fuse for the air bag, unless something else important is on that circuit.

i know the 35 isnt the best axle to use, but i have it, and there are plenty of parts out there new and used for decent prices if it breaks. i looked on randy's ring and pinion website, and found the break is 3.31/3.55, so just have to find one with 3.55's or better. for the front, i plan to...

i'm building an s10 and performing a sas using jeep axles. was wondering if there is a carrier break on the dana 35? and also wondering if axles out of a tj 35 are the same as a yj 35? thanks for helping on my chevy/jeep hybrid project.

thanks, thats what i was wondering. i know the gears won't work, i'll be buying 4.10's in the near future. hopefully an aussie too....

will a 3.73 carrier out of a low pinion d30 fit a high pinion d30? i just bought a low pinion from a grand cherokee for parts and was hoping it will work. thanks

thanks, well i probably will still just buy the whole hp 30 for the spare parts anyways, and just go 4.10's. Just realized this evening, it really needs gear, it is real lazy now with those heavy moabs and 285's....

i was just wondering if it would be any better than 3.55's with 33's? i am looking at a hp 30 for cheap from a guy on another forum complete from disk to disk with factory arms and everything else. and i have a line on an 8.25 with the same gears. even if the general consensus says no, i...

i've noticed when i'm driving my xj, when i get on it prety hard from a stop, or romp on it hard when off roading, my fan clutch hits the rad support bar. (little round rod that goes from the top to the bottom of the rad) i replaced my alternator yesterday and noticed its starting to dent the...