• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by lsc910

  1. L

    head gasket or motor swap

    Looking for opinion on the subject. I have a 93 cherokee with 304000 on the original motor. It has blow by and the head gasket just took a crap. What does everyone think i should do. Im looking at around 300 for checking the head out and parts and around 450/500 for a used motor from a yard...
  2. L

    brakes locking up

    Hi its been a while since I've been on the sight. I have a 00 xj and the past 2 weeks or so when I first start driving and apply the brakes the front brakes lock up. More the right front than the left. It only happens every once in a while but i can't seem to see any problems. the front brakes...
  3. L

    98 grand cherokee rear suspension

    I have a 98 grand cherokee and the rear spring bushings are worn out. The dealer ship has 1 available the other is on backorder. They look the same is it possible to use the same one on both sides? the number I have is 52088379 from the dealer. Thanks for the info in advance.
  4. L

    27 spline to 29 spline

    the ring gear on the 27 spline stuff is 3.55 but the 29 spline stuff is 3.07 and just setting the carrier and ring gear isn't that bad
  5. L

    27 spline to 29 spline

    This may sound dumb to some of you guys on here but I just picked up an 8.25 27 spline rear and want to know if I was to get a carrier and axles out of a 29 spline will bolt right in or are there differences, also will the ring gear fit on the other. Thanks for the answer in advance
  6. L

    coil on plug brackets

    thanks cause the way I was understanding the brackets were something more than what you need.
  7. L

    coil on plug brackets

    thanks, hopefully it will be very helpful and I can fab something similar up for mine
  8. L

    coil on plug brackets

    Ok, I've read on hear and a few other sites that people are swapping out the heads on the newer motors for the older ones due to the overheating and cracking of the heads. I have a 00 xj and the motor came from a salvage yard and has a leaky head gasket so I just want to make the swap to the...
  9. L

    high pitched squeal

    Its not the belt. it sounds like somthing in the front of the trans. While diving it it will come and go when I hit the throttle and some times it will be there at idle. It seems that when it gets hot it happens more
  10. L

    high pitched squeal

    Hello this is driving me up a wall cause I cant figure it out. I have a 00 cherokee, 4.0l with aw4 trans and every now and then I have this high pitched squeal while driving it. When it happens and I hit the gas it goes away most of the time. today while driving it was there when I stopped so I...
  11. L

    93 Cherokee starts then shuts off after 1-2 seconds

    Hey I also have a 93 cherokee and had a similar problem last week and it turned out to be the ballist rersistor on the drivers fender well. It is up toward the fire wall and easy way to test it is to just put a jumper wire in between the two wires and try and start it, if it runs then thats the...
  12. L

    home brew long arm

    Hello everyone just have a few questions for all of you. I have a 93 cherokee with 5.25 inches of lift right now but I want to do long arms and don't have a lot of money. my lift consist of rough country adjustable upper and lower arms,4.5 inch rough country coils, and a 1 inch spacer. I have...
  13. L

    0331 head change results

    can someone please post pics of there bracket for the coil rail. I just replaced the motor on my wife's 00 with another 00 motor from a salvage yard but if I haev any problem with this head I'm going to swap it out with the older one that doesn't crack between 3 and 4.
  14. L

    Chronic, Intermittent, Cylinder misfire ! !

    Re: Cronic, Intermittent, Cylinder misfire ! ! Sounds kinda like a crank shaft position sensor problem. I had a similar problem a few moths ago with an autozone sensor. I put in in the sensor and every now and then it would set a code with multiple cylinder misfire on 1 or more of the...
  15. L

    Iron rock offroad inner axle sleeves

    So you have to plug weld them not weld the ends
Back
Top