Recent content by ericfx1984

and their owners

that kit on JC Whitney's site is a 3" add a leaf and a 1.5" shackle

rough country makes a quality product, I don;t regret mine

I had great results with my JK arm swap, running it in 4 link ATM though... planning to punch out the axle side upper bushing sleeve to allow for 3 link useage... rides way better than short arms and feels really controlled, and is way flexier than people expected it to be they are 18" uppers...

meant to write CRACK

no... most people run it all the way up to 6.5" or more of lift

mispost - delete

I would not put 35s on a dana 35... and no... more lift dos not mean more articulation... proper angles shackle angle, flexy springs, correct bump stopping, etc, that means better articulation

it would be neat to see someone attach the stock mechanical fan to an electric motor(to simulate the engine) and test it and different RPMs to figure out how many CFMs the mechanical fan pulls at idle all the way through redline

what axles are you going to run? I mean anything above 35s and even the best of the stock start to blow up there is a lot more to going taller than 35s than a big lift and fender trimming

it sounds like you guys are worried that piercejeeps is just trying to make MOUNTAINGARAGE look good... if that is the case then it is easy to figure out... the mods just need to look at the logs and see if they both have the same address... if they do then a banning is in order... if not...

to drill it out you will need to go slowly and use TONS of lube...

Look the guy just said he wanted 3" spacers... so I gave him 3" spacers... I personally would keep it 2" or under... but it's not my call the man tells me what he wants and give me money... simple as that I am a little un easy about the setup myself as well... I was from the get go... 3" i...

I have made close to 2 dozen coil spacer sets... with no problems... Fat bobs garage sells a 3" TJ coil spacer set... they report no problems... it is setup the same way... if it is good enough for them it is good enough for me... the guy wanted to buy a set of spacers... then he asked me...

have you seen how they mount from the factory...???