Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I was wondering if I was missing the point.....
I guess not, it dose apperar to be debatable it seems.
I've seen some sad axles being removed on YouTube!
Mine mostly had wet sand .
Going to run with the two 1/4" hole idea, too let out out any future water entry.
But will tap a thread into...
Hi guys, open to opinion on my front end.*
I've just pressed out my ball and uni joints.*
I removed the diff bung, and corked an air compressor pistol into it, and had a nice air flow coming out of the axel tube ( blocking one end at a time)*
This allowed me to use a correct sized wire...
Oh, thanx Tim,
So if my tacho and Speedo need a tap to get going sometimes...
And contacts look very clean.
Internal issue?
Or poor contact terminal?
Is there a diagram of connectors that show the grounding pins? In case they are poor?
There is the cluster check , keep finger on odometer when turning ignition on.
My contacts look great and clean. But I often have to tap the dash to get p
RPM and Speedo working..?? Illumination lights are spastic as wel
Thanx heaps guys. I got some spider joints delivered today, plus a pair of the better outer seal kits.
$220 au !
We call it jeep tax here!
Yes SBR Off road where very helpful.
Going to hold off for a week till I can afford the ball joint kit.
$340au...(terraflex) do it all in one hit.
Will...
Been bloody 20 years since I've fitted a set.
As there any issue with taking too the old uni and just cutting it twice just inside the yolk?
All care of course, but would it make it easier to press out ?
Thanks guys!
My rig has the 8.25 Chrysler.
Are the 4 uni joints all the same on the prop shafts front and back?
Did any jeeps come out standard with a double cardan on the rear that can be swapped into 97 XJ ?
Cheers guys!
With cross referencing jeep parts in oz, it seems there is like a copyright on them.
You just end up with dumb blank looks!
As if they don't get a hit their computers!
Painfull!
And I think eBay should force sellers to disclose country of Origin!
Sick of Chinese CRAP!
Have you had that pin checked at the ECU? Not the harness included, to exclude wiring issue?
All mine where crisp from fatigue!
I chased them all the way to the point they left the fire wall to the motor. Before this they where still supple from ECU/ pcm.
After trimming them at al, fire...
Hi, pick your brains please!
Got a 97 XJ, and soon to put new hubs in.
(No abs) standard D30.
So I think ... what the heck, axles are out. So I might as well put new "U" joints on the front axles.
Plus new upper and lower joints.
Make a day of it!
BUT... are the axel "U" joints the same...
Yeah, it's on an 8.25. It was a bit of test of patience dialing it all in correctly before with the LSD carrier. But swapped over to open with a Spartan.
I just couldn't see the big fuss over putting the ring gear back on exactly the same bolt line up to the carrier.