Recent content by Danwa

Cleaning out garage: I have a hard to find, AC compressor delete bracket and a brand new in packaging RENIX fuel injection quick connect fitting if anyone is interested.

Sounds like a winner. I'll give that a try. Thanks for the sound advice joe_peters! Most appreciated.

I am using Chevron dexron mercon. I do have about 30k on the fluid. I typically do drain down and partial refill. I have not done a full transfusion or ever dropped the pan. I use this as a daily driver and don't do very much towing. Do you think I did any damage? I stopped and pulled over as...

I have a 1988 with the AW-4 automatic. I was heading up a fairly steep pass with transmission in the power mode. I suddenly started to hear a whining noise similar to what a power steering pump sounds like with no fluid. I then pulled over and lifted the hood. Puffs of smoke were coming out...

Your situation sounds very similar to mine. I got hit in the hitch. I never noticed any damage until the adjuster showed me where the uniframe had buckled slightly, no body damage whatsoever. They had to put it on a frame straightener and pull it out that way. The offenders insurance company...

My 1988 would do the exact popping your talking about when my exhaust manifold had cracks in it. I have replaced mine twice in 255k miles. Both times I would get those symptoms under high load or rpm's. Pop Pop Pop...

Yes, that's the one, #54. I will try backing out and doing the silicone thing. Good idea, thanks!

Yes Kastein and others, I was worried about internals issues. I think I read somewhere that there was a detented shaft and spring connected to that plug. Anyhow, again, it appears to be brass right at the bottom of the case. I do know where the drain and fill plugs are, I just wanted to get...

Does anyone know what the small brass plug at the bottom of the np242 transfer case is? It appears to be leaking. This is on an 88 cherokee. Thanks

Thanks for the input, much appreciated.

My previous experience with Dorman products has been good. They have been known for their quality in the aftermarket. I have a new Dorman exhaust manifold. It's working great. Hope this helps

I have an 88 Cherokee. I think I may be bleeding current in the blower circuit somewhere. With the key off, I read 13 ma at the battery. I then took out the blower fuse at the fuse block and the draw went to zero. Anyone had issues with there blower controls? Maybe the switch? Thanks

I have a 2000 wrangler cover on my 1988. It works great

Again, I had the exact same problem you are having. The 2 issues I had were exhaust related. I had a cracked exhaust manifold, and the vacuum transducer on my EGR valve was full of crud, causing it to stroke too much, and the engine would sometimes quit. I cleaned that out and swapped the...

My 1988 w/AW-4 does exactly what you are describing. I had a severly cracked exhaust manifold. I just replaced it this weekend, MAJOR! improvement. I also am noticing more power also, always a good thing.