Recent content by AMERCANZERO

I was trying to send you a pm but your box is full. You can email me at [email protected]. I would like to discuss this axle. Thanks.

I have a spool for a d44. It has been used but looks to be in good condition. No visible chips or scrapes that I saw when I was looking at it. If you are interested, let me know.

I am interested in your parts. I live in HighPoint and Im in GSO almost every day. Can we meet somewhere? Maybe sometime saturday? I will PM you my phone#

They are the right ones you are looking for. Let me know if you want them. They are in excellent condition, we pulled them off of a Jeep we put some other wheels on. Let me know if you are interested. I think I already said this but I have the center caps as well, also in great condition.

Are you talking about the square holes, like they put on wranglers. If so I have a set - Im in Greensboro. I have the center caps as well. Ill look when I get home and count the holes. If these arent the wheels you speak of just ignore this comment.

Im new to the RTI but what does the degree of the ramp matter? I thought you could lift it straight up with a forklift as long as you get the height off the floor measurement. I just read all that stuff in the link posted near the beginning of the thread, I still cannot understand how the...

Bigger tires give the ground clearance. Shackles give you room for bigger tires. Shackles + Bigger tires = More clearance Control arm drops are fairly inexpensive and give added flex. The only trouble with the stock arms is the inability to resist damage. They will be fine to start off with...

Have seen a few of these over at the Jeepspeed part of the forum and always liked the way they looked on prerunner desert trucks. I posted a while back when I finished building it and a few guys said they liked it. One asked how it was going to mount. I finally got it up on the HEEP and took a...

I did search, didnt find what I needed. I want to do the mod to hold the fork in the locked position. My question is in the removal of the other vacuum lines. I read a couple of places that you could block the main vacuum line in the engine bay (the red one I believe) and remove all the other...

I just bought some from a guy on ebay. The spacers are hub centric but they are not wheelcentric you have to use the beveled lug nuts to center the rim. They were a little more than half price of what you would pay to get them from spidertrax or quadratec and they are made from the same...

Lead shot will rust, I think, stick to plastic. I have 9oz of .20g dense air soft bbs in my 34s and I dont think its quite enough but the balance is great up to a certain point. When I get above 60mph I get a small vibration. I think I just need a little bit more in each tire. With the airsoft...

The stuff they dont manufacture in-house would definitely be alright. In that case they are just third party. I own their Bar Pin Eliminators, which they make, and they are pretty heavy duty, 3/8 steel with good looking welds. I, personally havent had many negative experiences with their...

At (6) 130w lights I would start to think about electrical load. Im sure thats something youve thought about. Im an electrician by trade so I get all worried when I think about the things people do with power and the extra heat and all that mess. I hope it comes out the way you want it to. Im...

I dont have a pic of it mounted yet. I am going to finish painting it and mount it Sat morning. I will post a pic Saturday night.

I just built a light bar similar to that style. Mine is rigid. If I had to do it again I would do it hinged like in your reference picture. I hope it goes well!