bradleyheathhays
NAXJA Forum User
- Location
- Lexington, KY
Hopefully I'm not missing something here but just looking at this seems like a fairly simple job. Haven't done this one yet so just wanted to run it past everybody real fast.
My driver door actuator is attached to a L bracket that appears to be riveted to the inside of my door.
From what I can see I need to drill out the rivets, disconnect the actuator from the lock and electrically, remove the bracket and put it on the new actuator, and reinstall with two short bolts where the rivets were.
Any thing I need to know about or steps I've missed?
I'll also be replacing both actuators in the rear doors as well. Any specific advice there?
Thanks
My driver door actuator is attached to a L bracket that appears to be riveted to the inside of my door.
From what I can see I need to drill out the rivets, disconnect the actuator from the lock and electrically, remove the bracket and put it on the new actuator, and reinstall with two short bolts where the rivets were.
Any thing I need to know about or steps I've missed?
I'll also be replacing both actuators in the rear doors as well. Any specific advice there?
Thanks