Hi All,
I am planning on replacing the front wheel bearings on my 96 Cherokee (4wd, 4.0, auto, AC, Dyna 30, Chrylser rear). The driver side bearing is very loose and lots of noise while on the highway. The vehicle has 125k, not much off roading yet.
Since the front will be apart anyway, I figured it might be time to replace the upper / lower ball joints and or u-joints axle shaft assy. Is there anyway to tell if they are worn out, or should I just replace them.
If replacement is necessary on the u-joint axle assy, should I go with new or remanufactured?
Thanks!
I am planning on replacing the front wheel bearings on my 96 Cherokee (4wd, 4.0, auto, AC, Dyna 30, Chrylser rear). The driver side bearing is very loose and lots of noise while on the highway. The vehicle has 125k, not much off roading yet.
Since the front will be apart anyway, I figured it might be time to replace the upper / lower ball joints and or u-joints axle shaft assy. Is there anyway to tell if they are worn out, or should I just replace them.
If replacement is necessary on the u-joint axle assy, should I go with new or remanufactured?
Thanks!
Last edited: