Changed the pitman arm out last night for a DPA, and noticed that there is a rubber bushing on the the box slides up and down slightly on the pitman shaft.
In other words, when I got to it - the bushing had slid down the thicker splined portion of the shaft and was resting on top of the pitman arm. I stuffed it back into the box opening, but I'm sure it will come out again.
There's enough there to keep junk from entering the box, but dunno if this will impact the life of the bearing, etc.
Any thoughts?
In other words, when I got to it - the bushing had slid down the thicker splined portion of the shaft and was resting on top of the pitman arm. I stuffed it back into the box opening, but I'm sure it will come out again.
There's enough there to keep junk from entering the box, but dunno if this will impact the life of the bearing, etc.
Any thoughts?