so my u joints went bad on my 89. The saddle ones. So i took them apart then i put the first u joint in then the next one didnt have enough clearance to fit in the other saddle. The center yoke ball is shot and the bearing were all tossed around inside. So o rileys told me 40bucks for ball kit- 100bucks for hole saddle and ball kit installed. 40BUCKS for a damn ball bearing is ridiculous. So what you guys think i should do? I dont want to get a junkyard one because i have a v8xj and i dont want to put a pos saddle back in. So what you guys think i should do?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
centering yoke ball bearing
- Thread starter projectTK
- Start date
Slip Kid
That'll buff right out
- Location
- A cornfield in IL
That's about what I paid for it. It was not hard to install.
- Location
- San Bruno, CA.
Pull your purse out and spend some money.
Beezle
NAXJA Forum User
- Location
- thornton CO
hahahaha! :roll:
good info here:
http://www.mallcrawlin.com/forum/showthread.php?t=7478
I just used a socket and hammer, it looks like the ring wont fit in there but it does, and you will know if its greased up real good when you whack it and it squirts grease all over your face.
Similar threads
