I recut my fender and raised my left front flare as high as possibile tonight. I need to cut/form a junkyard flare so it goes down to the bumper and fits tight to the body. A small piece will fill the gap caused by raising the flare. I will also be folding the rest of the seam, cutting and reforming the front inner fender for maximum tire clearance. A inner fender liner is in the works too. The weld in rockrails will fill the bottom 2" below the flare.
Here's a pic with 33" tires and 6" of lift
The flare is 4" higher then stock. The opening behind the tire is 4" larger at the bottom of the fender and 4" larger in the front at top of the bumper hieght.
Here's a pic with 33" tires and 6" of lift
The flare is 4" higher then stock. The opening behind the tire is 4" larger at the bottom of the fender and 4" larger in the front at top of the bumper hieght.