• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

ID'ing axles...

kewlkatdady

NAXJA Forum User
Location
Mansfield TX
I picked up a HP D44/ 9" combo from a '79 bronco.

I'm wondering if there is a website or something else that I can ID these axles with just to make sure they are what I think they are.

I have all the numbers off the ID tags from the axles.

I may be over thinking this too much but that is just the way that I am.

Any help is appreciated.

TIA
 
I understand that much...

what do the numbers on the ID tags means?

Here they are:
HP D44:
3 00 D9TA BBB
610088 - 6

9":
WDM-CH 8MC
3 00 9 620A


What do they mean?
 
What are you wanting to know about them?

The tags should show the gear ratio.

If they are from a '79 the 9" will have 3/8 bolts that hold on the brake backing plates and axle retaining plates, opposed to the 1/2" bolts found on '78 and older models. The hp44 will have cast on radius arm mounts as opposed to the welded on ones.
 
It should be a heavy duty (reinforced housing) big bearing 31 spline.

sorry I didn't understand your question earlier.
 
Back
Top