- Location
- Port Orchard, WA
hey,
i just got assigned an open ended CAD project for my MECH 130 CAD class at UNL, and am interested in drawing an Orthgraphic of a 1.25" lift shackle (that i hope to eventualy build) and am interested in the specs of a stock shackle.
I need the following to know:
Top width - ??
Bottom width - ID is 2.5" +about 1/16" on both sides for bushing clearance so bottom ID is 2 5/8"
Length of stock shackle Eye to Eye - ?
clearances for the top area in the shackle box (if anyone has that) - ?
Bolt size - i should know this, but dont remember.
Bushing diameter (top end) - does this have a cut out and two different layers?
any nifty ideas that i should do? Boomerang?
i just got assigned an open ended CAD project for my MECH 130 CAD class at UNL, and am interested in drawing an Orthgraphic of a 1.25" lift shackle (that i hope to eventualy build) and am interested in the specs of a stock shackle.
I need the following to know:
Top width - ??
Bottom width - ID is 2.5" +about 1/16" on both sides for bushing clearance so bottom ID is 2 5/8"
Length of stock shackle Eye to Eye - ?
clearances for the top area in the shackle box (if anyone has that) - ?
Bolt size - i should know this, but dont remember.
Bushing diameter (top end) - does this have a cut out and two different layers?
any nifty ideas that i should do? Boomerang?