tompatjr
NAXJA Forum User
- Location
- Hayneville,AL
I replaced the cracked exhaust manifold and according to the FSM all bolts should be torqued to spec.
Is there any need for me to go back and re check the torque after the engine has been run a time or two?
I was able to get a strait shot on most bolts with the torque wrench, but several I had to use a swivel. I would guess at about a 30 degree angle. I know it wasn't accurate, but better than just guessing.
Is there any need for me to go back and re check the torque after the engine has been run a time or two?
I was able to get a strait shot on most bolts with the torque wrench, but several I had to use a swivel. I would guess at about a 30 degree angle. I know it wasn't accurate, but better than just guessing.