Replacement Flexplate to TC Bolts (4)

Has anyone had any luck finding an online site that had replacement bolts which actually fit for FP to TC?

I was looking at
http://m.autozone.com/nuts-bolts-an...erter-bolt-for-chrysler/193899_0_0/?location=

I don't want to reuse the ones I have, but every website I see isn't very specific if it's the bolt I'm looking for.

Or am I best off just asking a dealer (I think after 15 yrs though most dealers don't carry service part stock)?

2001 Jeep Cherokee Classic AW4

Sent from my SM-G900V using Tapatalk

Dealership carries them. They are not expensive.

The bolts are used in shear, not in tension. There is very little reason to replace them unless they were loose and the chafing wore on the sides.

old_man said:

The bolts are used in shear, not in tension. There is very little reason to replace them unless they were loose and the chafing wore on the sides.

Click to expand...

This will be the third time I've had to remove them, after being thread locked. This last time I used the red locker.

I'm hearing some slight wobble/vibrations from right underneath the cab, and believe the TC isn't bolted completely flush with FP.

My concern was that after removing for the 3rd time, they may have lost their strength and not worth reusing...especially after heating to get free of the red thread locker.

Sent from my SM-G900V using Tapatalk

Here's the new replacement bolts you would get from the dealer.


.
This will give you an idea of what they cost:

http://www.moparamerica.com/oe-mopar/6504383

Sidewinder CC said:

Here's the new replacement bolts you would get from the dealer.

.
This will give you an idea of what they cost:

http://www.moparamerica.com/oe-mopar/6504383

Click to expand...

Puuurrfect! Exactly what I was looking for.

Although chances are reusing the same bolts would be OK, I'm willing to spend the extra $20 to alleviate my concerns. Lol.

Sent from my SM-G900V using Tapatalk