Kingkong0192
NAXJA Forum User
- Location
- New Milford, CT
Here's the information i'm currently looking at.
The only thing i don't know is when it says the U-joint for the front axle is the 5-297x does that mean just the ones for the front axle shafts, or does that mean the one on the driveshaft?
Also, even though it says these, can you upgrade a U-joint without changing the yoke or anything like that?
Front Axles -
Dana 30 high pinion - reverse cut - 27 spline, 1.16" diameter shafts, 7.13" ring gear - used 84-99 (some axles through 91 are vacuum disconnect, 92+ are non-disconnect, 89-95 with ABS have 5-297x u-joints, all 95+ have 5-297x u-joints, all others have 5-260x u-joints except 84 thru 86 they were CV type rather than open u-joints)
Dana 30 low pinion - standard cut - 27 spline, 1.16" diameter shafts, 7.13" ring gear, 5-297x u-joints - used 00-01
D35s and C8.25s have the same U-joint, and it's the 1310.
The only thing i don't know is when it says the U-joint for the front axle is the 5-297x does that mean just the ones for the front axle shafts, or does that mean the one on the driveshaft?
Also, even though it says these, can you upgrade a U-joint without changing the yoke or anything like that?
Front Axles -
Dana 30 high pinion - reverse cut - 27 spline, 1.16" diameter shafts, 7.13" ring gear - used 84-99 (some axles through 91 are vacuum disconnect, 92+ are non-disconnect, 89-95 with ABS have 5-297x u-joints, all 95+ have 5-297x u-joints, all others have 5-260x u-joints except 84 thru 86 they were CV type rather than open u-joints)
Dana 30 low pinion - standard cut - 27 spline, 1.16" diameter shafts, 7.13" ring gear, 5-297x u-joints - used 00-01
D35s and C8.25s have the same U-joint, and it's the 1310.