Moble tech needed

Well, the title states it all if anyone is not working and could help me with getting it started i will pay them. Its 93 GC 207,000 I6 I have a new starter, Batt and cap coil wires and plugs. I found that the rotor was fried under the cap upon inspection, replaced it still cranking but no fire and a new fuel pump. I had the spark tester on it and i dont see any spark. I'm at the end of the line on what to do next if someone could help me get rollin again that would be awesome.

Thanks in advance

Check the crank sensor. If it's bad(very common) you will not have spark.

The crank sensors are a common problem. Also the ignition coil goes bad on those. Check for signal from crank sensor on coil side.

Thanks guys need to check this out in the early am eace:

If you don't have it fixed yet, call me, nein five wun, tu tu five, fi fi fi wun.

Fixed it was the distributor, cps will have its time i'm sure but for now its runnin good for 200 g's on the ticker. Distributor was about 18yrs old :scared: