Track bar advice needed

I just finished my steering set up and now I need to finalize my trackbar plan, but I need some help. So I am thinking of getting this bracket for the frame http://www.ballisticfabrication.com/...t-_p_1669.html and then I am going to offset this bracket http://www.ballisticfabrication.com/...nt_p_1399.html on the axle tube. Then I am going to order some DOM and heims and put it all together. The problem that I am having is if I want to have the axle mount 6" or 7" high. I know that I want to keep the angle the same(why I am getting the adjustable mount) just looking for advice. Pics of the angles and height




Any comments advice would be awesome.

I just went ahead and ordered the two brackets, heims, tube adaptors and tubing only $140. It should ship out monday so I will update as I go

where you buy tube and adapters? looks good, I plan on doing this setup someday.. good luck post pics as you go!

I bought everything from ballistic fab, including the steering.

While we are on the subject . . .the frame side bracket has adjustable holes at 2 1/2", 3 1/2" and 4 1/2" drop from the frame and the axle side is supposed to be 7" off of the frame (a little above the UCA mount) but it will be tilted off center so it will be only 5-6" higher off the axle tube.

Do you think I could just weld the bracket to the frame or do I need to weld it to an piece and then bolt that to the frame?

you could easily just weld it to the frame. however... you might consider welding on some reinforcement on the frame prior to welding the bracket. even if it is some 1/8" or 10ga. i would go as far as possible on either side of the bracket with the reinforcement as well.