- Location
- Virginia City, NV
So I just picked up a HP44 flat top knuckles with lockouts and disks 5x5.5 pattern and the welded on mounts. I have a couple of questions about where to go from here. I have some money alocated for this axle but I also would like to keep the dollars to a min. I'm not afraid to pull and clean parts if its going to work.
1. Will I still be able to use 15inch rims(just bought 35x15s)
2. what is the easiest way to convert this to 6bolt pattern
3. I'm going to be shortening it to waggy width. Where do i find the measurments to cut.
I'm new to the dana 44 and I read through crashes sticky but I need the nuts and bolts info. If there is anywhere to find that please feel free to link.
Also any recomendations would be apreciated. Thanks gents
gordon
1. Will I still be able to use 15inch rims(just bought 35x15s)
2. what is the easiest way to convert this to 6bolt pattern
3. I'm going to be shortening it to waggy width. Where do i find the measurments to cut.
I'm new to the dana 44 and I read through crashes sticky but I need the nuts and bolts info. If there is anywhere to find that please feel free to link.
Also any recomendations would be apreciated. Thanks gents
gordon