Pnwxj808
NAXJA Forum User
- Location
- Port orchard WA
So I ended up using a nut and a bolt to get it slightly out on the upper section but the scrap plates I had weren’t long enough so I used a piece of a longer steel I had but it wasn’t strong enough and bent so I’m going to try and get a piece of 1/4 inch angle iron and attempt it again! Hopefully it gets me close enough. I made a template today for tie in brackets and used the passenger side because it was straight but when I moved it over to the DRS side I was off half a hole on each one because of the smash. Good thing I didn’t order already made brackets haha
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk