Search results

I have a '95 XJ that has been giving me some issues. I doubt all are related but going to list them all here in case I am wrong and I can tie some of them together. I recently put in a rebuilt motor because the old one was burning 4 quarts between changes and started losing lifters...it was...

The vacuum boot actually split while the Jeep was running on the freeway. Genuine Bosch injectors, all new.

Tried searching and didn't come up with anything. Been having issues lately with my '95 XJ, 4.0. A while ago, I had upgraded to the 19lb Bosch 4-hole injectors and it ran great until a few weeks ago. It started when I was driving home and I had a vacuum boot split on the fuel pressure...

I thought I had my old pieces but can't find them. Went to the JY today for a few other things and pulled apart a few other PV's and they are all the same. I even grabbed a new set of ZJ guts and have the same problem...I am stumped.

The rubber cap came off of the nipple at the front of the proportioning valve, which is where brake fluid is now coming out of whenever I step on the pedal.

I am having an issue with my proportioning valve. I have searched and had no luck finding any mention of this anywhere. I recently added rear discs to my XJ and did the 'ZJ guts' swap. Everything was fine and dandy until I went to start bleeding the brakes. As soon as I stepped on the pedal...

Oil pressure is good, sounds more top end and higher pitched than I'd expect for rod knock. But it's usually while I'm driving that I can hear it so hard to say I'm hearing correctly.

I have a '95 XJ with a 4.0 that has ~287k miles on the clock. For a while now, I've had a clattering in the engine at higher RPMs. It seems to come in at ~2500-3000 RPM but hard acceleration seems to help until ~3500-4000 RPM. It will linger down to ~2500 RPM when I am off-throttle...

Might not be quite what you're looking for but a couple manufacturer I've seen make molle panels that attach in front of that cubby. Makes the cubby useable plus gives you added storage on the front of the molle panel.

I have a few things off my '95 XJ for sale, all prices are obo -Warrior Products Rear Bumper. Some minor finish chipping and surface rust but otherwise in great shape. - $200 -Euro Style Taillights. Has one cracked ear on the lower mount 'slot', otherwise in nearly perfect condition. - $50...

I have a rear bumper for sale, asking $200 but I am negotiable. I also have a set of Euro style taillights (see second picture above) for sale if you're interested.

Sadly, no. I did need the glass run but that is for the operable glass side of the division bar, too deep to use on the solid glass. The whole bar might help but I need the passenger side.

I have been working on repairing a few lingering issues on my '95 XJ, one of which is dried-up glass seals. I have been able to track down almost every seal except for the rear door 'quarter glass' at the division bar. I have also not been able to track down the seal for the solid 'vent'...

Good idea; I had looked there once before, will have to check again! Would be better if they all had pictures to check the color. I've seen it called both blue and green so without a picture, who knows if it's even the right color

I know this is probably a long shot: I have been searching for parts for about 3 or 4 years now to repair a fender bender (literally) on my XJ. The accident damaged the drivers fender, the header panel, and a few other plastic parts in that area. I found some cheap replacement parts to get by...

I have a '95 XJ that I am having trouble finding a replacement rear wiper motor. The Cardone reman has those cheesy tap splices instead of a new plug and I'd rather take my chances at a junk yard over having to re-wire a "new" part. Has anyone found an alternative source for a new wiper motor...

I made the mistake of taking the needle off my speedometer in my '95 XJ and it seems to be mis-aligned now. When I initially installed it aligned with the stop, it was WAY off but then installed it pointed below the stop (and rotated it back around) and it was close to accurate. However, it is...

Sold.

Sold.

I mistyped, $20 and it's yours. LED lights work just fine.