Search results

its a 95 cherokee country 4.0, replaced alt a/c pullie swaped fan pullies. you can see that the belt is shearding on the outer edge like its getting pulled out. Owner said balencer was replaced before. could it have walked out or replaced with the wrong part? are there any other common causes...

I am getting code po301 which is clynder one missfire. new plugs wires cap rotor, tps, and injector. it has a random slight hesitation under light acceleration but does not happen often. I only notice a slight miss when at idle. what should I check next. thanks

I bought these http://www.transmissionpartsusa.com/...-00094393a.htm. I found the link on here http://www.naxja.org/forum/showthread.php?t=996259 these look diferent want to make sure they will work before I take it apart thanks

just did a tps test on my 97 xj, I am showing 5.12 volts at idle and 5.11 at wot. is this bad??

doea anyone have a TCU wiring diagram for a 1997 xj. I need to test my seleniods and can only find a TCU diagram for a older xj. thanks

1995 cherokee nothing on the hvac works. I have checked the fuses, the blower fuse was blown I replaced it and still nothing. jumped the blower motor to the bat and it runs. I pulled the hvac control out there is a little rust around some of the wires. I pulled the blower motor resistor out it...

97 xj with aw4 trans. it skips 2nd and goes to 3rd and does not downshift. the codes are po700 and po753. how do i check the seliniods and could it just be the tcu. What else should I check?

Do i need another tcu from a 97 or can I use one from a newer model? thanks

I have a 97xj with aw4 trans. It shifts from 1st to 3rd and skips 2nd also does not seem to downshift when in drive. heres what i have done so far new seleniods trans flush and filter adjusted the cable on t-body new tps what should i do next?