Search results

as the title says i have a leak on my fuel rail where it connects to the hose(the section that is closest to the firewall) how should i go around fixing this? FYI:, i have another thread on this sitre about my jeep bogging and surging when you give it gas, i think this might be my problem let...

4.0 aw4, I'm sure some of u guys know me well here for trying to fix my rig, well I finially got it started but now another problem. It runs but if u give it any gas it falls on it face, it bogs, surges, basically doesn't want to drive unless u barely give it gas. So what should I look at...

I have an 1987 jeep commanche, aw4 tranny, with 4x4. As of right now, the problem is this, the starter engages the motor(turns the motor once or twice and then stops,(and it doesn't sound good). Seems to me that signal to tell the starter to turn is stopping when you have the key turned in the...

It's a renix inline six with an auto, And I'm stuck at work now,. I hear the fuel pump prime, and assoon as engine starts it dies, i drove to work with no problem an now the jeep is throwing a hissy fit, any idea what I should look to b the problem, keep in mind I have no tools

I have a renix motor that left me stranded six months ago(blew a hole in the side of the block the size of a dime, and a hole threw the oil pan) I've trans-planted another motor and head into my jeep. during the tear down of the "new" motor I noticed alot of carbon build up in the intake runners...

The plastic orange gear that is connected to a rod, is that part suppost to be attached to the cable and not come off? Basically I'm asking this because mine came off the cable line when I pulled the motor and tranny and now my speedo doesn't work, so I'm guessing the cable and gear assembely...

Well I'm back agian looking for help with my 87 wag. Well I took the jeep out for the first test drive after the motor swap and killing all the germlins that I encountered during this swap. I have rattling sound that seems to be coming from the exhaust(which was present before the swap) and...

Basically I have two different starters, the orginal and a 1996 that came from a doner xj. Both were tested today at pepboys and passed. Niether one of the starters will turn. I have the positive lead from the battery going to the large post, and a green wire that comes from the starter relay...

So I'm trying to replace the seal that is at the end of the tranny(after the transfer case) where the rear drive shaft slips into the rear of the tranny. If anyone knows what it's call or a part number for it would be a life saver I have been to every auto store and they either don't carry it...

Is a flexplate from a 89xj the same as an 87xj?

So I just purchased a new torque convertor and I need to know what kind of fluid do I put in it, and how much do I put in it, by the way I have a 87 wagoneer with a aw4 and 4wheel drive

Looking to start learning to weld, and I don't have the money to buy a millermatic, anyone know where I should start looking for something for a beginner

I have a 87 wagoneer, with a aw4 with a transfercase (npxx), in December I blew the motor(loss oil pressure) well I got a ho engine from a 96 xj, so after swapping over all the accessories and bolting the "new" engine to my tranny, the jeep starts but doesn't engage any gearbexcepy park, I've...