• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Search results

  1. O

    V8 swap question

    Has anyone that has done the V8 swap used the factory AW4 shifter on a 700r4 or a 4l60?
  2. O

    fuel line size

    Can anyone tell me the size of the steel fuel line for a xj? I'm not close to my jeep right now to measure.
  3. O

    4.0 engine swap ?

    I have a 99' grand cherokee 4.0/auto/4x4 that has a severe engine knock. I have a low mileage 4.0/aw4 from a 98' cherokee. Does anyone know if the 98'xj 4.0 will be a direct swap into the grand?
  4. O

    NP 231 problem

    I just swapped a 231 with a sye into my 90 xj. It had a 242 in it. I dont have 2 wheel high range now. I unhooked the shifter linkage and shifted the case manually and still dont have 2 wheel. It has 4l and 4hi. Any ideas? I havent pulled the case and split it yet. Its a 90, 4.0, aw4, 6.5 long...
  5. O

    Front driveshaft bolts

    Does anyone know what size bolts to use for the front driveshaft at the front t-case output? Its for a 90 model 4.0, aw4, 231 I have had the front shaft out of it for a while and missplaced the bolts for it. It is a cv shaft.
  6. O

    Axle swap ?

    I have searched and havent found what I need to know. I have a 90 xj, 4.0,aw4,sye 231, that I am finishing a 6.5 inch RC long arm kit on. I am swapping in a pair of tj rubi 44's. Both axles are bolted under it now but I am having issues with steering wanting to bind up. I am trying to use the...
  7. O

    Needing opinions on lift kits

    I am looking for opinions on the best bolt on 4.5" lift kit for a dual purpose 90' xj. Its a daily driver / weekend toy. I mainly wheel on sandy river bottoms so I am wanting to be able to go fast with a good ride. I am mainly looking at either the rough country 4.5 long arm kit or the RE 4.5...
  8. O

    Renix engine swap ?

    I have a complete 88 4.0, harness [underhood and dash] ecm, tranny, and t-case. I am about to pick up a 98 xj that is minus, engine, trans, case, underhood harness, and ecm. How hard would it be to swap the renix into the 98?
  9. O

    Xj problem

    I have a problem with my 90 model and I am looking for ideas. The jeep starts fine but has a dead spot around 1000 to 1350rpm. It will rev past the dead spot but as soon as it idles down it will die. It will refire just fine and idle after that. It has also started to idle rough after about 5...
Back
Top