Search results

Finally had time to swap a set of D44 Rubicon axles under my xj, The axles are out of a 2016 JK with 8,000 miles my buddy swapped out for a set of Rock Jock 70's.. I went with Artec trusses and Ruff Stuff perches and U bolts...

Since I started pulling the teardrop I've been Ok with a new coolant system but I'm wanting to go out west again next summer and I'd really like to use the air conditioning. So I need to get the winch out from in front of grill and install a tranny cooler.

I have a 98 xj D30/8.25, 456 gears and a spartan in the rear. My wife uses it as a DD and we pull are teardrop camper with it. I recently drove it from WV to California and ran the Rubicon in it, now I need to upgrade everything because I want to go to Easter Jeep in the spring. I have a set of...

Hey guy's I've been around a long time and I've alway's found and fixed all other problems without help but this one's got me stumped. I bought a 91xj (4.0 auto) story was they (po) swapped in a motor (from a 94xj) and now have a no start condition. I changed the crank sensor and now it will...

First off I'd like to thank you guy's, I've searched on here for years and fixed alot of xj's from your advice. This one I'm going to have to post on, a friend's 99xj aw4/231 die's randomly when turning left only. It alway's starts right back up but very dangerous for his wife to drive and she...

I bought this out of a 89 4.0, 5 speed xj. It's a 231 with a sye and the input has 21 splines. My question is can I make this work in my 87 xj with a auto and a 231, or should I just sell it and buy a new one? Thanks.

I haven't posted much because I usually find what I need too with search but I need some advise. I've got a 86 with a 2.8, body is excellent and runs good just underpowered. I've been looking for a 4.0 xj to swap my lift and stuff too. I found a 87 2dr with a D44, LSD,410's, skids and front and...

Hi, new here. I had a click every now and then in 4hi/lo thought it was an axle joint. After my 3in lift it's real bad now. So that's the top knucle of the driveshaft since the diff side joint is new right? Is that funny lookin thing rebuildable? Or should I try to swap it out, my searches have...