Search results

Was curious as to whether or not the 4.0 engine was used in other vehicles other than the jeep. Such as Chrysler autos or other. The few xj's that I find in our local pick-a-parts look like a turkey the day after Thansgiving. Anyone out there know of any other sources? Thanks Don

I was wondering if someone could tell me what the sensor is and what it does. It is on passenger side of block and has wires going to distributor. I cannot find it in my service manual at all. Thanks for any info. Don

My ignition doesn't come back to acc position and hasn't since I bought the xj. I thought it might be in need of adjustment, but it seems the dimmer switch uses the two same screws as the ignition switch. Was wondering how you set one without disturbing the other. Also was wondering if this...

Was wondering if anyone out there had specs. or drawing of Sanden Compressor dipstick. I need to drain and replace oil in mine and need a way to measure the oil level. Thanks

Was lazy the other day and let a quicky lube place change my oil and filter, lube, and check the axles, TC, and Trannie. I told them to just check the fluid levels and not add anything as I used synthetic gear oil in trannie and axles. The manager asked me if I used a gasket or RTV on the axles...

Was wondering if the 4 door xj had a sun roof as an option? I saw a nice one on a 2 door at the pick a part that I almost bought to put on my 88 xj 4 dr. But mine has the corrugations on the roof that appear to be in the way. Was concerned about it leaking, even if I flattened them out to do...

Hi Fellers: Just a simple question. Have an 88xj 4wd 4.0, BA15, Command trax. Ever since I've had it, it takes about 5 seconds to fire up after I engage the starter. Hot, cold, same thing. I thought maybe valve in fuel pump, but does the same thing if you turn key on and wait several seconds...

FYI.....Carquest has a new "to me" bleeder valve for brakes that has a one way valve in it to enable you to bleed your brakes by yourself. They come in pairs and the smaller one will fit the bleeder on my 88 xj internal slave cylinder. May be useful for bleeding or flushing system. You just...

Just installed new clutch and internal slave on 1988 XJ, 4.0 engine, BA10/5 Trannie. Last slave was leaking. Am unfamiliar with hydraulic clutches, and was wondering if someone with same could tell me how far the cluch pedal should depress before feeling any resistance. The old clutch would...

Just wondered if anyone could tell me where to purchase a fill plug remover for 10/5 trannie? Or do I just grind down 3/8 extension to fit plug? Thanx