Search results

Ok, so I installed the PORC SYE, and everything seemed pretty good install wise, besides the fact that I didn't use enough permatex on the bottom of the housing,so I have a slight oil leak. I'm running it in 4H without a rear driveshaft (aka, badass FWD jeep), but it likes to pop out of 4H and...

Ok, everything was going smooth,and well,it's always something. I got to the top 12 point 10mm bolt, and well, it's stripped to kindom come now. Any suggestions? I'm really pissed right now. What's the point of that thing anyways?

Ok, so I've got pics on my 8.8 install. So far my main problem is that the perches welded on are way to small. My main question is my pinion angle. What should it look like a full droop? is that too much of an angle? Right now the u-joint by the t-case is resting on the yoke as you can see in...

Ok, basicly I'm asking if I would be able to do a regear for my Dana 30. I picked up a 8.8 w/ 3.73's, and I need to match the front. I'm restoring a 67' mustang, done all kinds of projects on my jeep (the 8.8, brakes, the lift, ect.),replaced the timing belt and waterpump on a 300zx, but I...

Ok, I had my 8.8 welded today, and well, all seems to be well (besides me forgetting to take the U-Bolts into consideration, but a little bit of grinding will get them on). The problem is, my spring perches are 1.5 inches wide (he used some he had in the shop), while the leaves are of course...

My question is, has anyboy/ can I use the swaybar bracket as my shock mounting tabs?

I have a 95 manual 4.0 xj, and at highway speeds I always overheat. When ever I get on the highway speeds, I can watch the temprature steadily rise until it hits the red zone. Usually I end up stopping at a gas station to let it cool down. I also overheat while offroading too. I was thinking...

Ok, so I've had my S-10 leave for quite awhile. Getting ready to put them in, which will net me 4.5 inches probably,which is the requirment for a sye. My x-fercase is in the need of replacement. Instead of buying another np231 50 bucks at a junkyard, and then paying another 169 bucks to get a...

Ok, so I found a front 4.10 axle out of an '85 cherokee Cheif. Someone has already taken the axle shafts, brakes, ect. Can I slide in my axle shafts from my '95 3.08 axle? Thanks.

Ok, I have a 95 SE, 4.0l, 8.25 rearend, manual transmission, and oh course 4x4. Long story short, I broke my pinion yoke, and had it towed to a local shop, becasue at first I though it only had a broken bolt in it. But none the less, I don't have access to it yet, because the guy that was going...

Do I need to buy the 1 inch chain, or the 1 1/4 inch chain? Also, anytips on installing the chain? Thanks.

I did a search, but everyone elses problem seems to be a little different. Anyways, I have a 95 XJ, AX-15 of course, and the problem is the clutch pedal is REALLY hard. Like, brake pedal hard. The clutch engages hard too. But, if I'm at say, a stop light or something, then the first time I let...

Here's a video of a Hit-and-run, or more like hit and try to hit again. Starts off slow, but gets intresting. Warning, explicit language. CLick here to view

I was off doing some trail riding for the first time in my Jeep I purchased about 2 1/2 months ago, when I heard a popping/ clunking sound coming from what sounded like the kinda front middle of the Jeep. It only does it in 4wd drive, and it sounds like it happens more in 4 low, and more when...

Ok, I have a 95 4.0l XJ. The A/c works awesomely, as long as the temp is on high (not the fan speed, that works at wahtever speed), but as soon as you kick the temp down a couple of notches, it starts to blow nothign but outside air. On a related note (mabey), I don't think my cruise control...

Looking for a place to wheel around me, preferably a sandy place (never done that before, looks intresting). The only places I can find to wheel are the little powerline road/path things.

My check engine light has been coming on recently, so I pulled up the code via the ignition trick. Pulled up erro code 24. Hayes says that the TPS sensor's voltage is either too migh or too low. I don't think anyting is acting funny with my engine, so what should I do? How do you test the...

Ok, I have a 95 XJ. The clutch pedal is REALLY stiff. To the point where my knee hurts whenever I drive it. Whats wrong, and how can it be fixed? Also, the pedal has about an inch of play in it, mabey more. How do you adjust it? Or is it something else? That's about it for today, beside the...

I recently bought a 95 XJ (3 weeks ago) And have pretty much fixed the problems with it, accept for a couple/ new ones. First, my aux. fan wasn't coming on at all. I plugged it directly to the battery, and it span. But, it was wobally (sp.?) and looked like it was going to pop off at any moment...

The electric fan on my 95 Cherokee never comes on. It dosn't come one when I turn on the A/C or anything. I'm assuming its the fan itself. I also have a 97 Cherokee. Would it bolt right into the 95? Would that even be a task worth doing?