Search results

Rolling out early. 😁

Looking for clarification on the Milwaukee drawing. If we are not a current member, there is a $30 extra charge to become or renew during registration. So, is everyone that pre-registers entered, then? Or does the NAXJA membership have to already exist? Just checking. I already have one...

Do you come to Utah, ever? I have a Detoursusa swing out carrier for sale. :-)

If using the calculator, be sure to measure your tire height. Mine are 35s, but between being km2's and having 50000 miles on them, they measure 33. And inputting 33 puts the calculator pretty close to my GPS verified speeds.

For the gears, you could count driveshaft rotations if you don't want to pull the cover. Lift just one rear tire off the ground. Mark the driveshaft and count rotations as the tire is manually turned. The spider gears will cut the ds revolutions in half. So turn the tire 10 times, and divide...

For the gears, you could count driveshaft rotations if you don't want to pull the cover. Lift just one rear tire off the ground. Mark the driveshaft and count rotations as the tire is manually turned one complete rotation. The spider gears will make the ds go double time, so divide the...

I got the Atlas 4 speed. It has been installed and in DD use since June 2008 and I could not be happier. Worth every penny, to me. However, I have a manual trans. The low-low ratios may not be AS heavenly with an auto as they are for me. I have the 10.34 box. That one gives you 2.72 ratio...

If they are driver drop, it should be 1980 or newer. I also went with a tnt truss. It makes it very easy. It made me feel a lot better about the uca mounts, as I was weary of welding to cast iron for the driver side. I think the j10 axles are wider, aren't they? Mine (and most I see) are from...

Don't worry about it until there is a problem. They weren't failing on the road or trail - the joints were just wearing out prematurely. So there will be warning signs before there is a real issue. The center grease joint is placed similarly. If you are looking to lube it in place, it is very...

Another vote for Tatton's. Curtis does great work. I had the exact same issues with 2 TW shafts as described above. Switched to Tatton, changed nothing else, and problems went away. Although, TW sells thousands of shafts. If everyone had these problems, they'd be out of business. This has to...

Here are the folks that made it out today: There will probably be a rough 2016 chapter schedule coming soon from the new Management. :looney: Stay tuned.

I would be there.

Anyone want to run Rusty Nail or Moab Rim on Saturday for a "difficult" run?

Leafs and jks gone - the longer, new, Tereflex shackles are still available.

I'll briefly be there. Probably running on Saturday only. We have a big Disneyland adventure a couple weeks earlier and I can't swing any vacation time. :-)

Taylorsville, near 5400 s and Redwood road.

She took it very graciously, as did Steve. I've never seen people less shaken up over a tip or roll...much classier than I would have been. :-)

Glad you made it home, Steve, and of course, that you both are OK. Anything in particular you'd be looking for in a new Jeep that we can keep an eye out for? Ryan probably already has a line on 10 of them. :greensmok Here is the video of the flop...

PM'd. See you in...7 hours. :peace:

I put the feelers out to the few people I know that may have been interested. I am doing like Steve and driving down in the morning and home at night. I am playing at a bar Friday, and will be there till 1am. It'll be a short night. :-)