Search results

got a 93 xj ax15. was out wheeling a while ago in the snow. got a little stuck so i tried to revers out of where i was. after a little while while in reverse it started making a knocking sound. but i kept going. then normal driving it still made the slight knocking sound in reverse, clutch...

1993 4.0 so i was driving home from class yesterday and my jeep just stopped running. i pulled it over and it will start, run for a few seconds and then die. if when i start it i mash on the gas and keep the needle bouncing above 3k it will stay running. any ideas? i checked the dist cap...

saturday night did a 2.5 foot water crossing went home 10 minutes away and parked the jeep. sunday i started it ran it for a half hour listening to music and usung a small dc compressor. this morning went to start it and nothing. jumped it, drove to work, the voltmeter read 17 volts, so i turned...

93 4.0 ax15 so i was driving down the interstate today and put it in 5th (rarely do 31s on 3.07s) and as soon as i let off the gas it popped out of 5th. the shifter moved maybe 1/4 inch. it didnt come out into the neutral position, but it wasnt enaged in 5th. and i could hear a very slight...

93 ax15 every now and then it wont shift into first while stopped/ shifts real hard. and sitting at lights in first with clutch depressed it will pull forward just a little in a pulsing manner. im thinking mc or throwout bearing. anyone know for sure? or what to look for?

i never liked the whole upside down tow hook hanging on the bottom of the bumper so i made my own setup. any thing you like/ dislike? other than i should've cut my hole in bumper better, and tied the steering box brace to the farther back open hole.

my jeep started making some chirping noises from under the driver seat today. also when i start from a stop or change gears i hear a clicking noise. i looked under it and it appears as if i have a front output seal leak. dirty around shaft and atf slung up in the tunnel and everywhere. is this...

ive searched but none of it worked. i have some led taillights and i cant get them to work right. my problem is that both sides flash when i use the turn signal with parking lights on or off, and when the brakes are on there is no flashing just brakes. i have the grounds all grounded)blacks...

ok so after work today me and my buddy decided to drive up a huge dirt pile. i went first and i got about half way up and was just spinning so i reversed out. then i went a little faster in 2nd and right near the top i got too light on the gas and stalled. eek. tried to start it and it wouldnt...

when im in 4hi it will pop out then back in. this usually only happens when the jeep is cold. after 5 minutes of driving or so it will stay in 4hi fine.im thinking low fluid but theres snow on the ground, so im not gonna check it if i dont have to. 93 ax15 np231j

i have a 93 xj with 3.07s(d30 front,chry 8.25 rear). i also have a parts jeep 86 xj with 4.10s(d30 disco front,d35 rear). i want the 4.10s on my 93. would the rear axle be a direct fit? or just a swap of the yokes? also how would i make the front axle work without converting the 93 to have some...

i got a thermostat housing that will supposedly make me run cooler. i put it on and it leaked squirted af from the bottom. so i took it off cleaned the surfaces real well used som more rtv in the leaky spot put back on. still leaked. repated taking off and putting on about 5 times. finally i...

93 xj 4.0HO 22xxxxmiles so for the past 3 months ive been adding coolant, about every 4 weeks id see its at the add line, it never went under that, until today. it always operated right at abouit 200 to 210 today it got to about 240. i just added some coolant the other day though. there is no...

ok so in the past week when ever id accelerate my clutch pedal would come up, and while decelerating it would pop back down. ive diagnosed this as needing a new tranny mount and prolly motor mounts. so i ordered both on thursday. i decided to still drive my jeep around on friday and 10 miles...

so i disconnected tonight then when i went to reconnect i had to have a bud lift up my left side bumper to reconnect it. i looked and notcied that the bracket that hold the lower pin is bent down and im pretty sure my sway bar is twisted. im think this is from an accidental jumping with my jeep...

yeah after i put 31s on my xj 4.0 ho it seens liker it ALOT weaker than it used to be. like if im going up any hill at all i need to downshift. im talking about the slightest inclines. i know i have a bad cat could that be causing me this weakness? its got a new dist cap and rotor, and a cai...

ok so im going on vaction on friday and i get my new 31s thursday, i put on a lift a week ago, the rustys bb. now the question is i was going to wait to get aligned til after i get my tires on but, i dont think ill have time from thursday night til i leave friday morning, but i want my new tires...

ok so on ym xj i think the yoke sleeve is worn, as there is slop in the rear driveshaft and its not comeing from the ujpoints. could i use a tjs output shaft and housing to fix this? or what do i need?

i want to run some 31x10.5s, im thinking about getting new wheels, just some steel rockcrawler type, but im wondering what offset is correct for what i want. they will be 15x8 wheels so that would stick the tire a half inch closer if it had stock offset rigth? so i want another 1/2 of offset or...

can anyone tell me how teh wires to the heater control are supposed to go. i got this 93 cherk a couple weeks ago and on teh back of teh heater control there are 5 little male receivers sticking out, that are controlled by the fan power switch wheel thing, and then there were 4 wires with...