• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Search results

  1. T

    4.0 - replaced entire cooling system, still overheating

    Hey all - I have a lengthy thread on CF.com about this but it seems to have run its course and a cross-post can't hurt. 95 4.0 5-speed on 35s/4.88s with a motor from a 97; it idles fine but temp likes to live just to the right of 210, but when I'm at 50MPH or faster, it gets up to 230-235 or...
  2. T

    Getting welded HP44 - locker or not?

    Hey all - I'm getting a HP44 from a guy who's been running it in an XJ. It's out of a 79 F250 and it's got manual locking hubs. Is it worth the expense to put a locker in instead, or leave it the way it is? I am getting it regeared to 4.88, so if I do a locker, the time would be now. I do...
  3. T

    Guy welding 8.8 for me - can I determine correct angles without the XJ?

    Hey all - the guy that's regearing an 8.8 for me is also going to weld on the new spring perches and shock mounts. He says all he needs to know where to put them is the old 8.25, so my plan was to pull it out of the XJ and bring both rears to him. BUT The XJ's been lifted 6.5", now has an...
  4. T

    Crossmember bolt spins (broken weld?) - how to remove??

    Hey all - trying to remove the tranny/TC crossmember. 3 bolts came out fine, one turns with difficulty and makes a metallic squeal. Searching seems to indicate the weld on the nut, buried inside the frame, broke loose. The bolt is still intact and is single-handedly holding up the...
  5. T

    How far can I drop AX15 to get TC off without damaging anything?

    Hey all - need to rebuild my np231 on my 95 XJ. There's an excellent youtube from BleepinJeep on how to pull an np231, but it's from an xj in a junkyard, so he just drops the tranny/tc as far as it will fall, which makes it hella easier to work on, but no doubt the motor mounts/radiator/lots of...
  6. T

    Can I rebuild this np231?

    Hey all - long story short, bought my first XJ earlier this week, 95 AX15 on a 6.5" lift with 35s, otherwise mostly stock. Sounded a little noisy when I test-drove it but I didn't know any better. Going down the highway on Thursday and the rear driveshaft u-joint let go - very dramatic. Had...
  7. T

    Please help - which NP231 for '95 AX15??

    Hey all - I am SO confused. I've done a ton of research and have found so much conflicting information. I have a 95 XJ AX15 4x4 with a blown transfer case. I'm looking for another np231 - this Novak chart seems to indicate that a post-90 AW4 np231 would also be 23-spline but would have a...
Back
Top