Recent content by XJ01-08

I accept

Re: Moab photos Nice, I added the few videos I took on Kane Creek, got one of you, Chuck, and Rob

Sadly the days of the baofeng UV5r are over, most of em got cracked down on by the FCC so supposedly cant transmit on FRS and GMRS frequencies now, they can still listen and im not sure programming them can fix it. Transmit frequency range: VHF 144-148MHz and UHF 420-450 MHz FRS and GMRS are...

Yeah Im hard on them, they get used as sliders and get hit against ledges. Good thing is since they are all straight links they are easy to replace with aluminum.

Not too impressed with my clayton 3link, all my links have slight bends to them now. Bent the top link when it hit the floor pan and at full stop on the steering with 35s the tires rub on the lower links. If i had to do it over again id go with Iron Rocks, the bends in the arms give more...

Sent Jesse a PM, If I could avoid shipping ill do $80.

Little surface rust, could possibly bead blast them if I have time $100

16x8 and 3.75"bs is what I had to use on mine, wish I went 17s but I had the tires already. Ran 8" wide with my 33s and now have 35s, no issues with either.

WJ steering with offset 1 ton tie rods I couldn't run 15"s, even 16"s at 3.75bs barely fit.

I have a few laying around, free if I can find it or I have a few 30s laying around I can steal one off of.

Does the ring gear have a set of metric and standard threaded holes? Ran into a ring gear like that doing one of my friends 8.25s, the standard bolts will go in the metric holes and will torque close to spec, luckily we had a few strip before they were up to full torque or we wouldn't have...

Working Friday so most likely Ill meet up at the park on Saturday.

Time to try and clear out some of the parts I have laying around. JCR 96 and down tail light boxes. Has light surface rust but ill bead blast them if you want. $100 OBO Set of XJ Brown dog Rubber Motor mounts, rubber bushings are wore out, set of replacement bushings are $10 from them. $50...

O2 sensor simulators and weld 2 bungs for the upstream sensors on the new manifold/header.