Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Just replaced both 02 senors not 2 days ago, now my light is back on and it is reading high voltage to the 02 senors. it runs fine on the highway but when you stop at a red light it will start missing and stalling. I have done some searching, what i need to know is, what will cause the high...
I understand black to black grey to grey, but mine has 4 wires and the other two are both white. I am not sure where they go or if it is possible that I may have them backwards.
I have had hard starts from time to time. its funny though because when I do have a hard start the check engine...
I have a 2000 XJ.
The Wires on the sensor got ripped in half by the drive shaft yoke. there is a black, gray, and 2 white wires.
What are the white wires, and will it hurt if they are backwards. I have reatatched them but i am not sure they are correct.
thanks for any input.
Heath
what is the best way to get the inner c to break loose from the tubes. I have cut the weld s with a cut off wheel but the knuckle still does not want to budge. any suggestions???
later Heath
I am starting my axle build up, and have a couple of ??? I am also wanting to run a 36/ 37 tire. I have a matching set 44/9 combo 5on 5.5 hole pattern. I also have a full float 60 rear with 8 lug pattern. Should I stay with the matching set, or find a set of 8 lug outers for the HP44. its not a...
Tires are brand new not even 50 miles on them Tie rods and all of the steering is new as well I have built all of it myself. I was thinking it was the caster but wanted some other opinions. Ball joints and unit bearings are good to go as well.
thanks for the reply.
Heath
First, I have searched!
I have an 88 with 6.5 inches of lift, 33/12.50/15 Maxxis bighorns.
I have already converted the steering got the draglink and track bar angles correct.
after hitting a bump the jeep will start to wobble mainly at lower speeds say about 30/40. running down the...
rick thanks for all the info, thanks to everyone else for the response as well.
I also have an 88 that I have removed the cat on and it helped power and fuel mileage a good bit. Looks like the cat will stay on the 2000.
later Heath