Recent content by WOLFINSANITY

I believe you still need to do something with the in tank filter and mod the pick up tube or something, but if you leave the old filter in place, it will still choke the gas flow. You still need to remove all needed to drop the tank or cut an access hole, then mod the pump/filter, then add an...

I never thought of that one, since I tried before with just a puller and nothing, I just PBed it and then never had time to get back to it other than keep spraying PB on it now and then. So I will try that when I get the chance to, also I'm glad I ran out of time and didn't heat it after all...

acknowleging your problem is just one step closer to recovery. This thread realy had me laughing the way it evolved.

Did you try heating the pitman? That may expand it enough to get the PB in further or to just come off with that alone. Not sure though.

I believe you can. And I am sure there is a seal kit to close the disconnect fork hole on the axle too.

Wouldnt PB Blaster work to help free the pitman?

I would also make sure the shocks were good and gas charged kind to help ease the sag

Wow, nice thread. I agree with banning phones in line while ordering, but also agree that there could be exceptions to the rule if no one else is in line and bussiness in slow for the sake of getting an order straight. But to go crazy and bazerk on people over opinions I don't agree on. There...