Recent content by wes3337684

coil ohms out good, I am now also getting code p0340, already changed the cam/ pick up sensor and checked wiring. Is there any way to ohm out the wires going to the cam/ pick up sensor

I tried to check for timing chain slack, I put #1 at TDC and the harmonic balancer there also, then slowly turned the crank the opposite direction til the rotor turned. Looks like I had to move the crank to the 5 degree mark until the rotor began the turn. I that to much play?? Can't find a spec...

No didn't remove the distributor to install the cam sensor. Runs fine only a slight miss at idle in drive that I can feel and see in the tech moving ever so slightly.

Reset the ecu, code came back 2nd time I started the engine. What should I try next? The distributor doesn't have any side to side play only some play when I try to turn the rotor back and forth and I can't find any info about how much play in allowable, should I replace to distributor??

Hi everyone long time looker first time poster, I have a 98xj 4.0 Auto, its got 283k on it with only minor issues like freeze plug leaking into bell housing :confused1. Now I have the p1391 code, put in new Mopar crank sensor still have code, put in new Mopar cam/ pick up sensor coil, still has...