Recent content by tricker

just to update because I dug through alot of threads over the past few months and hated finding no end threads IT HAS STARTED AND RAN for about a day now, no issues discovered other than its still trying to find the right idle after i started getting a little spark( by removing all the...

if i put my spark tester inline from the coil to a good ground i get a faint spark....nothing when connected to rotor

I'm getting no ground switching at A7 Where do I go next? thanks or the help so far!

I am using an inline spark tester between coil and cap/rotor

definitely getting signal from the crankshaft position sensor... no spark

appear to be getting signal....

I only have a digital multimeter so I don't know a really good way to tell

Firstly, thank you for your help! These check out, still no spark....I've thrown all the parts at it I know to and even some I don't Are you willing to guide me a little further to remedy the issue? ALL help is MUCH appreciated

I ran directly from pin 7, pin 7 is constant ground

I have no ground switching occuring.... Also my CEL doesn't come on with ignition start any longer....is the PCM fried?

thanks!

Can someone tell me where the signal wire for the coil ties into the pcm?

I believe my signal wire to the coil is grounded somewhere, so the coil never fires....to bypass this ground which pin do i need to tie into at the pcm?

moved relays around, still getting nothing from the coil anywhere else to look?

wasn't camshaft pos sensor either....not sure where to go